BG EN

MEASURING EQUIPMENT


ANALYZERS FOR THE QUALITY OF ELECTRICAL POWER


bulet Power Harmonics Analyser MI 2092


Three-phase, multifunction analyzer for evaluating the quality of the electrical power suitable for implementation of all the most common measurement and diagnosis of various electrical systems.

bulet Power Monitor MI 4100

Power Monitor is a multifunctional tool, making precise measurements of single or three-phase system.

bulet Power Q MI 2492

Power quality apparatus evaluates and adjusts systems for low and medium voltage. These devices check equipment which affects the quality of electricity. It is able to make a harmonic spectral analysis for a selected filter. Verification of UPS, generators and regulators. Monitor and record voltages, currents, power. Monitor and record energy consumption.

- Power Simulator Set MI 2191

Simulation of transient processes, interruption in the power supply, etc. Selection of the nature of the load, the level of current and voltage with the help of simulation of 22 different defective conditions. Option for the version: 110 V.


EQUIPMENT FOR TESTING THE SAFETY OF INSTALLATIONS


bulet Earth - Insulation Tester MI 2088

Multifunction, digital measuring instrument for testing of ground systems and systems for protection against lightnings. Test for continuity of the protective conductor PE and insulating resistance and low voltage systems according to EN 6 standard.

bulet MI 2166 Demo Board MI 2166

Simulatior of the general power system, which is usually designed for houses or apartmens. This simulation can be used when representing a measurement equipment in order to show all the capabilities of the apparatus for such measurements.

bulet Instaltest 61557 MI 2087 ST

There is a complete set of test procedures according to the standard IEC / EN 61557. Measurement of insulation resistance. Test for continuity of the protection conductor PE. Measurement of resistance of lines and circuits. Analysis of RCD protection with automatic test, test for the quantities dI, dt, Uc and measuring the resistance of the ground circuit. Measuring the frequency of the three-phase systems.


EQUIPMENT FOR TESTING THE INSULATION


bulet ISO Test MA 2060

Automatic calculation of PI, DAR and the DD index and measurement of capacity up to 50 µF. Custom test voltage of 250 V to 5000 V at a step of 50 V. Resistance range 5Om. Automatic switching off the load after the measurement is observed. Protecting device for eliminating the dangerous currents over the ground surface. Measuring AC and DC voltages up to 600 V.

bulet Tera Ohm 10kV MI 3200

General Characteristics:

Insulation resistance during tests 10 TOhm DC, voltage 500 V - 10 kV at step 25 V. Short-circuit current 5 mA. Main power supply or battery. Automatic discharge of capacity.

bulet Tera Ohm MI 2077

Automatic calculation of PI, DAR and the DD index and measurement of capacity up to 50 ?F. Custom test voltage of 250 V to 5000 V in step of 50 V. Resistance range 5Om. Automatic switching off the load after the measurement is observed. Protecting device for eliminating the dangerous currents over the ground surface. Measuring AC and DC voltages up to 600 V.